Linux Commando: How to mount USB drives on VirtualBox

This is part 3 of the 4-part series on VirtualBox. This post shows you how to access, from your guest OS, a flash drive mounted on the Debian host. Parts 1, 2 and 4 demonstrate how to build a FreeBSD virtual machine using VirtualBox on a Debian host, perform post-installation tasks, and share folders.

Prerequisites

The VirtualBox extension pack must be installed on the VirtualBox host. See part 2 for instructions.

Configuring USB

Follow the steps below to configure VirtualBox USB.

Add user to vboxusers group.
VirtualBox access to the host's USB drives is only granted to users of the vboxusers group. As root on the host, run the following command to add each VirtualBox user (e.g., peter) to the group.
```
 # usermod -aG vboxusers peter
```
Power off VM.
VirtualBox defaults to using USB Controller 1.1 (OHCI). Modern hardware uses USB Controller 2.0(EHCI) and USB Controller 3.0(xHCI). Before you can change the USB controller protocol, the virtual machine must be powered off.
Open VirtualBox Manager, click Settings, and select USB.

Specify USB Controller.
Select either USB 2.0 (EHCI) Controller or USB 3.0 (xHCI) Controller according to your actual hardware.

Note that you can add USB Device Filters to define the types of USB drives which will be automatically made visible to the guest OS. Be forewarned that the USB drive, once made visible to the guest OS, will no longer be available to the host. More on the use of device filters in the next section.

Accessing USB drive

Below is the step-by-step procedure to mount and access a flash drive.

Insert the flash drive into your host machine's USB port.
Unmount the flash drive (if it is auto-mounted on your host).
Making it available to the guest will automatically and instantly unmount it from the host. To avoid any data loss due to pending writes to the drive, it is a good practice to explicitly unmount the drive prior to handing control to the guest.
Power on the FreeBSD guest.
Assign USB drive to guest OS.

Open the virtual system console, and right click the USB drive icon.

Click to select your USB drive.

Note that this is a 1-time assignment only. Please see instructions at the end of the section on how to automatically assign this particular USB drive for all subsequent sessions.
Login to FreeBSD, and mount the drive.
You can mount a MS-DOS based flash drive by running the following commands as root. Replace /dev/da0s1 with the proper device identifier for your USB drive. (You can find out the exact device ID by first running dmesg to identify the device name, e.g. da0, and fdisk to reveal the disk partition structure, e.g., s1.)
```
 # mkdir -p  /media/usb
 # mount -t msdosfs  /dev/da0s1  /media/usb
```
To unmount the drive,
```
 # umount /media/usb
```